Differences

This shows you the differences between two versions of the page.

--- presses:poco [2026/09/24 20:23] – [Packing and Bed Adjustment for Photopolymer Plates & Type High Blocks] mbpdocs_admin
+++ presses:poco [2026/09/24 20:27] (current) – [Poco Troubleshooting, Maintenance and Resources] mbpdocs_admin
@@ Line 1: / Line 1: @@
-====== Poco Troubleshooting, Maintenance and Resources ======
+====== Hacker Poco No. 0 Troubleshooting, Maintenance and Resources ======
 ===== Packing and Bed Adjustment for Photopolymer Plates & Type High Blocks =====
@@ Line 55: / Line 55: @@
 To prevent having to rip out your cylinder packing every time you switch methods, you should establish a permanent type-high (.918") standard on your cylinder. Here is how to manage both setups seamlessly:
-==== 1. The Fixed Cylinder Packing Setup ====
+==== The Fixed Cylinder Packing Setup ====
 Pack your cylinder exactly to .052 inches (your .050" undercut + .002" squeeze). Use a hard packing recipe to accommodate both mediums beautifully:
@@ Line 65: / Line 65: @@
 Once this is clamped tight, leave it alone. Do not change it when swapping forms.
-==== 2. Form Adjustments in the Press Bed ====
+==== Form Adjustments in the Press Bed ====
 Because your press packing is now locked into a strict .918" type-high expectation, you will manage your two different forms directly on the bed: